Note: There is a maximum of 200 words per comment. If you wish to post more, please visit our forum.
Dismantlers cut, cart off 30 percent of ship's weight
By Jolene Guzman, Staff Writer
Tuesday, July 15, 2008 | 1 comment(s)
More Stories in this Section
- Fire agency enacts restrictions
- Port applies to buy rail line for $9.8M
- Fundraising heats up in Oregon senate race
- Court: land plan should consider wilderness
- Portland woman guilty in sculpture theft case
- Escape from state hospital raises questions
NB raises school lunch prices- Carissa’s Maine event
- City manager quits after annual review
- Dismantlers cut, cart off 30 percent of ship's weight
- Jackson Co. may oppose LNG pipeline
- Horizon says it doesn’t have enough planes to fly to North Bend
- Wis. woman accused of placing dead rat in food
- General Motors lays off salaried employees
- VW taps Tennessee for new U.S. production site
- Obama: Iraq distracting from other threats
- U.S. falls behind in push for science grads
- Economy faces ‘numerous difficulties’
- Police: Iraq suicide bombers kill 28 army recruits
- North Bend to close street temporarily
The New Carissa is on a slimming regimen.
Titan Salvage’s torches are burning through the 1999 shipwreck like calories on a StairMaster.
By Monday, the torch crews had taken off about 30 percent of weight of the stern and the appearance from the beach on the North Spit has changed dramatically. Much of what people are accustomed to seeing from shore is gone. Monday morning, the salvage crew took off two chunks in quick secession. They were rigged and swung away by Titan’s “Big Red” crane and added to the growing pile of rusty, seawater-smelling pieces on the Karlissa B barge.
“There won’t be as many visible changes in the next week,” Titan Managing Director David Parrot said.
Crews will be working inside the wreck, keeping the part of the hull intact as a breakwater against the waves, so workers can continue to cut. Within the next week, cutters may find they don’t have much left to work on.
Crews are installing anchors for the pullers on the barges in preparation for the next phase. That’s when they will wrench the wreck out of the sand.
“(Pulling) is the last big challenge of the job,” Parrot said. “Breaking it loose from the sand — it’s not as big a problem as we once thought.”
He said wave action has scoured out a basin around the wreck about 15 to 18 feet deep. While the wreck is sitting on a plug of sand and the portion beneath the water has taken on sand, it is not buried very deeply in it.
Parrot said one of three things could happen within the next week that will put Titan in a position to start pulling:
* There won’t be enough space on the barges to store the pieces coming off the wreck.
* Workmen won’t be able to cut down any farther.
* Or, the pullers will be ready.
Pulling up the wreck will allow crews to get to the engine room and propellor, where about 30 percent of the ship’s weight remains, without having to dive down into the water.
Titan Salvage’s torches are burning through the 1999 shipwreck like calories on a StairMaster.
By Monday, the torch crews had taken off about 30 percent of weight of the stern and the appearance from the beach on the North Spit has changed dramatically. Much of what people are accustomed to seeing from shore is gone. Monday morning, the salvage crew took off two chunks in quick secession. They were rigged and swung away by Titan’s “Big Red” crane and added to the growing pile of rusty, seawater-smelling pieces on the Karlissa B barge.
“There won’t be as many visible changes in the next week,” Titan Managing Director David Parrot said.
Crews will be working inside the wreck, keeping the part of the hull intact as a breakwater against the waves, so workers can continue to cut. Within the next week, cutters may find they don’t have much left to work on.
Crews are installing anchors for the pullers on the barges in preparation for the next phase. That’s when they will wrench the wreck out of the sand.
“(Pulling) is the last big challenge of the job,” Parrot said. “Breaking it loose from the sand — it’s not as big a problem as we once thought.”
He said wave action has scoured out a basin around the wreck about 15 to 18 feet deep. While the wreck is sitting on a plug of sand and the portion beneath the water has taken on sand, it is not buried very deeply in it.
Parrot said one of three things could happen within the next week that will put Titan in a position to start pulling:
* There won’t be enough space on the barges to store the pieces coming off the wreck.
* Workmen won’t be able to cut down any farther.
* Or, the pullers will be ready.
Pulling up the wreck will allow crews to get to the engine room and propellor, where about 30 percent of the ship’s weight remains, without having to dive down into the water.
The comments below are from users of theworldlink.com and do not necessarily represent the views of The World or Lee Enterprises. Participation Guidelines
Note: There is a maximum of 200 words per comment. If you wish to post more, please visit our forum.
Note: There is a maximum of 200 words per comment. If you wish to post more, please visit our forum.
Not already registered?
The World welcomes your comments about stories, and we encourage a robust dialogue on this site. All comments must meet reasonable standards of decency and civility.
Please follow these basic rules:
- No defamatory comments about individuals or businesses.
- No deliberately false information.
- No obscenity or racially offensive language.
- No harassment, verbal abuse, threats or personal attacks.
- No information that invades another person's privacy.
- No business solicitations or charitable solicitations.
Comments that violate these standards will not be posted. Users with repeated violations may be banned from future posting.Comments will be approved throughout the day during business hours. After hours and weekend comments may not appear until the following business day. It may take a couple of hours before comments are approved.
The World generally does not edit comments, but we reserve the right to edit any comment that does not meet our standards.
Close Guidelines